Just setup a test-meshnet

Technik Gluon
1

I have setup a quick test of my meshnet and would like to test it, I have loaded my custom Gluon firmware onto the two routers (TL-WA850RE 's ) and I would like to test the meshnet. How should I go about doing so?

Should I connect one via the ethernet port to my web server and try an access that over the mesh?

This is my connfig https://github.com/MaxNetMesh/maxnetmesh-site/blob/master/site/site.conf, I don’t know how to test the meshnet though, or how I should setup the Gluon settings in the Config Mode interface.

2

That will not work, because there is no DHCP server. You will have to assign static IPs or create exactly one DHCP in the mesh. If you need any help please say so!

1 „Gefällt mir“
3

There should be IPv6 connectivity already, because the nodes send out router advertisments.

1 „Gefällt mir“
4

I disabled IPv4 and left IPv6 enabled. Will that work, I seemed to get an IP address (v6) on my laptop. I think. :smile:

5

Should work… 20 chars long

1 „Gefällt mir“
6

I am going to try IPv4 again, and use static IP’s.

1 „Gefällt mir“