sfinp
6. Oktober 2020 um 18:04
1
In den letzten Wochen habe ich vier WDR-3600 über ebay gekauft und umgeflashed. Drei hatten Stock-FW drauf, einer kam mit openwrt. Letzterer ließ sich problemlos mit unserer Firmware hier im Saarland bespielen.
https://mgmt.saar.freifunk.net/firmware/stable/sysupgrade/gluon-ffsaar-1.9.0-tp-link-tl-wdr3600-v1-sysupgrade.bin
Die drei Router mit Stock-FW landeten nach dem flashen in einer Schleife. Sie kamen nach der Konfiguration immer wieder mit der Standard-IP 192.168.1.1 hoch und waren wie frisch resettet.
Workaround: Installation von 1.8.1, dann haben sie sich die Konfiguration behalten und kamen normal hoch. Ein anschließender upgrade auf die 1.9.0 funktioniert ohne Probleme.
Bin ich allein mit dieser Beobachtung?
sfinp
8. Oktober 2020 um 20:29
2
Habe mal ein Ticket eröffnet:
opened 06:18PM - 08 Oct 20 UTC
closed 08:58PM - 09 Oct 20 UTC
0. type: bug
3. topic: hardware
### Bug report
in the last days I bought 4 WDR-3600 on eBay and installed our… gluon-image to it:
https://mgmt.saar.freifunk.net/firmware/stable/sysupgrade/gluon-ffsaar-1.9.0-tp-link-tl-wdr3600-v1-sysupgrade.bin
One out of the four WDR-3600 came with openwrt, and this one did the migration to gluon without any trouble.
**What is the problem?**
The three others came with stock FW. After installing our gluon images to it they bootet with the standard configuration screen. So far, so good.
But after configuring them, they did not reboot to the normal operation mode, but came up with the configuration screen again, and again, and again ...
It looked like they never where able to store their configuration or like they where reset somehow again and again.
**What is the expected behaviour?**
Normally they should enter standard operation mode as soon as the configuration is done.
**Workaround**
The only way out was installing the gluon version 1.8.1
https://mgmt.saar.freifunk.net/firmware/1.8.1/sysupgrade/gluon-ffsaar-1.8.1-tp-link-tl-wdr3600-v1-sysupgrade.bin
Doing so enabled me to store the configuration and to boot to standard operation mode.
Afterwards I could do an upgrade to 1.9.0 whiteout any trouble.
Just installing 1.9.0 directly did not allow me to switch from config mode to normal operation.
**Gluon Version:**
1.9.0 / gluon-v2020.2 -> unable to finish config mode when installing on WDR-3600 with stock FW, reboot always led to config mode again.
1.8.1 / gluon-v2019.1.2 used as workaround with upgrading to 1.9.0 / gluon-v2020.2 afterwards
**Site Configuration:**
https://git.hacksaar.de/FreifunkSaar/gluon-site
**Custom patches:**
none